Squier Bullet Strat Setup

* Squier Bullet Strat Setup

Cort Hollowbody (setup + fretwire sanding/polish + fretboardclean)

* Setup + fretwire sanding/polish + fretboardclean, on a Cort hollowbody guitar
(the nut did not need any intervention to the slots, which rarely happens :) )

Vemuram Jan Ray Clone (118th pedal built)

* Vemuram Jan Ray Clone (118th pedal built)

 

Z Vex Box Of Rock Clone (117th pedal built)

* Just finished my first Z Vex Box Of Rock clone
117th pedal built so far

Ibanez RG350DX (setup+pup swap&rewiring+fretboard clean)

* Ibanez RG350DX (setup+pup swap&rewiring+fretboard clean)
- also had to sand down and refinish a fretwire (last one), because there was a nasty indentation in it that was very noticeable while playing; (it looked like a thin string was pressed against it very hard, making a knife like narrow groove)
- I cleaned the pots prior to redoing the wiring

 

 

Ibanez RG3XXV (setup+fretboard cleaning)

* Ibanez RG3XXV (setup+fretboard cleaning)

 

 

Ibanez S420 (setup,pup swap, fretboard clean)

* Ibanez S420 Setup + Pickups Swapped + Fretboard Cleaned
I also redid some solder points, and took out some wires that were unnecessary and long

 

Fender Jimmy Dale acoustic guitar

* Restrung and solved some stuff on a Fender Jimmy Dale acoustic guitar:

- the input jack fell in the body and there was no way to reinsert it back by hand as the body is very slim and you can't reach the hole; I had to be creative and take it out using a jack and some wire and add light in the guitar body hah! but I solved it;
- the owner wanted to add a locking strap pin, and I did that too, right next to the old one (that is on the input jack);
- restrung the guitar (no setup was needed, as he didn't request it, but the guitar was OK nevertheless as it was previously setup at some point, and I used the same gauge)