Old Reghin Hollow Body Rewiring

* An old Reghin hollow body style acoustic guitar with F holes came in for a quick rewiring (it was actually the same day before the owner's performance and I had little time to repair it because I was leaving for a wedding haha).

Changed the pot, the wires, retightened the jack input and also swapped the knob with an older used Fender US Musicmaster Knob <black> that I had around (I would of kept that cork diy thing but it was tightly glued to the old pot and it had to be destroyed for the pot swap)

Repaired a Denon 3808CI Receiver

* Repaired a Denon 3808CI receiver.

Quite a complex disassembly on this one. Two darlington power transistors were shot and a bunch of other parts as well due to a short at the output.

The work needed to get to the power section is quite a lot and the return in the end maybe isn't worth it,but I did it nonetheless.

Works like a charm now and sounds great

Before and after videos to show the symptom:

 

Made a Cornish Buffer (135th pedal built)

* Made a Cornish Buffer, I really like this circuit :D
Tried to make it very aestetically pleasing inside as usual for my wirings.

135th pedal built

Rewired an Epiphone LP Custom Pro

* Rewired an Epiphone LP Custom Pro,  with the provided SD SH6 in the bridge and a DiMarzio DP104 in the neck

Beyerdynamic DT770 Pro Headset driver repair

* Beyerdynamic DT770 Pro driver repair

The coil wires from one driver ruptured and had to be extended,and by that I mean physically soldered other thin copper wires on the remaining ones close to the coil (in addition to a broken wire in the headset anyway and that the wires came through the headset almost breaking off completely).
This was almost like a micro surgery hard repair haha,but I did it :D, and managed to reglue the whole driver membrane back.
The repaired driver works and sounds great now, just like the other one.

Yamaha F310 TBS acoustic guitar general clean and setup

* Yamaha F310 TBS acoustic guitar general clean and setup

It came in a very dirty state with quite a high action.

This was the dirtiest neck I have ever seen haha

CGCFAD tuning with a 12-56 gauge